high frequency welder Factory.Steps for replacing the flat pasting machine belt

　　1. Remove the large side panel cover, right small side panel, upper cover plate, and front support rod.

　　2. Remove the two screws above the feed side plate and the discharge side plate, loosen the lower screw, and let the front and rear side plates fall naturally. (Note: When disassembling or loosening screws, two people need to cooperate. One person should disassemble and the other should lift the side panel in front of it to prevent it from suddenly falling, and then gently lower it.)

　　3. Remove the springs on both sides and take out the upper and lower tension rollers.

　　4. Remove the upper and lower screws connecting the right wall panel.

　　5. Use a dedicated lifting rod for changing belts to lift the upper and lower right wall panels.

　　6. Two people work together to remove the upper and lower conveyor belts.

　　7. Replace the conveyor belt with a new one, which is the opposite of the previous process operation.

Read recommendations:

Hot plate welding machine electrothermal melting car head light cover PP PE plastic pallet water fuel tank

drawer type sliding table welding and cutting machine

manual HF high frequency round table welding machine

HF EVA welding machine.Metal carved board equipment

RF Polyester welding machine equipment.Do you know what an embossing machine is?